If the projection is blurry, focus it by moving the phone holder either backwards or forwards.Enter a dark room and play your photo, video, or movie. Now, insert your phone holder into the projector body (making sure that the photo, video, or movie is still upside down).On that same screen, make sure your phone is at its highest setting.To lock your screen, (on a IOS device) swipe up from the bottom edge of the phone and click the Portrait Orientation Lock and if it is on, it should turn red-orange.(The photo, video, or movie should flip its view) With this DIY project you can learn about light and optics, plus, you can get your creativity going by using this projector in your next artistic creation. Hold the phone holder with the phone attached to it, upside down. Did you know that you can build a smartphone projector out of everyday objects Well, you can, and it’s actually really simple.Open the video, photo, or movie that you want to project.(Try to tape down the edges of the phone to the holder) Tape your phone down at the center of the holder.Take your phone holder and lay it down on a flat surface.Now that you have completed the body of the projector, and the phone holder that goes into it, it is time to use it! Make sure the two rectangles together, form a right angle when looking at it from the side.Take your hot glue gun and attach the two rectangles, the longest sides touching each other.Cut the rectangles out by following the outline of the rectangles that you have drawn.(My rectangle was 2 inches by 6 3/8 inches) This will be your height for the bottom support. To make the bottom support for the phone holder, use the measurement of the width, and for the height of the rectangle, divide the height of your back support rectangle by 2.(I decided to shorten (My rectangle was 4 inches by 6 3/8 inches) Want to watch movies or dream about faraway places Make this DIY projector using a smartphone and a shoebox. To make the back support for the phone holder, use your height and width to make a rectangle.(The height of the box was 4 3/4 inches, but I chose to make the height of the phone holder 4 inches) (Make sure to write your measurement on a piece of paper so that you may remember the measurements when making this with the cardboard) This time, using the ruler, measure the height of your rectangular box.(The width of mine is 6 3/8 inches) (Make sure to write this down on a piece of paper so that you may remember the measurements when making this with the cardboard) Take your ruler and measure the width of your rectangular box.
0 Comments
Leave a Reply. |